MSW ATS automatic transfer switch 16a

Riello 16A automatic transfer switch MSW ATS

Code : MSW ATS

Operating principle

Multi Switch ATS 16 amp Dual inputs and 3 way distributed outputs 2 × 4 x10amp IEC 1 × 15A IEC (SNMP version)
The Multi-Switch provides electrical distribution and remote management for up to eight network users, powered from either one or two direct mains supplies or UPS or a combination of both.
Multi-Switch can connect each user (up to eight, each with a maximum power demands not greater than 3A), to either of the two power sources (A and B). Load demand is shown on the LCD

Protection against load faults

If one of the loads fails (e.g. short circuit), Multi-Switch ATS disconnects the group of sockets where the load is connected, thus preventing other loads from being switched off (i.e. in the event of poor selectivity of the protection devices).

Protection against power supply faults

If one of the two power sources falls outside tolerance levels, Multi-Switch ATS will transfer the consumers to the second power source (switching is instantaneous if the two sources are in phase).

  • Full protection for consumers against mains and load failures.
  • Versatile to use: Multi Switch ATS can be powered with 2 different power supplies (2 UPS even of different sizes/types).
  • 19” cabinet installation.
  • Display panel.
  • Can be connected to PowerNetGuard supervision software.
  • No signal connection between the Multi Switch ATS and the power sources or consumers is necessary.
  • Compatible with PowerShield³ software.
  • Slot for communications boards.
£547.07 ex VAT

The minimum order quantity is 1